Fibertel delivers fiber and telecom infrastructure as a subcontractor for network owners, prime contractors and suppliers in Vestfold.

We support FTTH and FTTB delivery from route work and duct systems through to splicing, termination and completion in distribution points, node locations and technical rooms.
Work is delivered with defined checkpoints, traceable labeling, testing where required and documentation that supports predictable handover and stable operations.

Areas we cover in VestfoldLarvik, Tønsberg, Horten, Holmestrand, and Sandefjord, as required.
What we typically deliver
• FTTH / FTTB installation and completion.
• Fiber blowing / jetting in ducts and microducts.
• Splicing and termination in distribution points, cabinets and node locations, including D5 closures and connection boxes when specified.
• Work in technical rooms and distribution cabinets.
• Test results and measurement reports, including OTDR when required.
• Photo documentation, labeling and as-built handover basis.

Network overview and cable routing plan

Typical assignments in Vestfold

• Termination in D5 closures and connection boxes with labeling, traceability and inspection.
• Fiber blowing and jetting in ducts and microducts, including setup, checkpoints and documentation.
• Splicing and termination in distribution points, cabinets and node locations, including measurements and OTDR when specified.
• Technical rooms and distribution cabinets: structured routing, patching, termination and documentation for handover.
• Fault repair and reinstatement: controlled handling of cable breaks, defects and nonconformities.

Project enquiry in Vestfold

Send a short description of the location, scope and preferred start date, and specify any requirements for testing or documentation.
We will confirm capacity and propose an execution plan, including checkpoints and handover requirements.

Coverage area in Vestfold (as required)
• Larvik • Tønsberg • Horten • Holmestrand

Splicing and Termination in D5 Closures and Connection Boxes (Vestfold)
We carry out splicing and termination in D5 closures and connection boxes with a focus on consistent labeling, traceability and documented verification.
Typical scope includes:
• Identification, labelling and update of connection references as required by the project.
• Fusion splicing and termination with clean fiber management and correct routing.
• Inspection and verification before close-up and sealing.
• Photo documentation and test results when specified, including OTDR where required.
• Close-out of defects and non-conformities before handover.

Technical Rooms in Vestfold - Patching, Termination and Handover Basis
In technical rooms, we focus on structure, clear interfaces and documentation that supports stable operations and efficient troubleshooting.
Typical scope includes:
• Structured routing, fibre management and consistent labelling in cabinets and frames.
• Patching and termination based on agreed port and circuit references.
• Photo documentation from key stages and final configuration.
• Test and measurement results when required.
• Handover basis and as-built documentation aligned with the project requirements.

Fibre Splicing and Termination (Vestfold)

Fibertel delivers fiber and telecom infrastructure as a subcontractor in Vestfold, Telemark and Buskerud.
Scope includes FTTH and FTTB delivery, fiber blowing / jetting, splicing and termination, work in nodes and technical rooms, and testing, documentation and handover.