fiber blowing and jetting

Fibertel provides fiber blowing and jetting for FTTH and FTTB projects in Vestfold, Telemark and Buskerud.

We install fiber through ducts and microducts, set up the blowing equipment on site, monitor the process during installation and deliver documentation according to project requirements.

Our work is suitable for network owners, main contractors, suppliers, housing associations, shared properties and selected private assignments where fiber needs to be installed, repaired, extended or re-routed.

When Is Fiber Blowing or Jetting Needed?
Fiber blowing or jetting is used when fiber needs to be installed through an existing duct, microduct or prepared route. It is often the right method when the distance is long, the route has bends, manual pulling is difficult, or a controlled installation is required.
Typical situations include:
• New FTTH or FTTB customer connections
• Fiber from outdoor connection point to technical room
• Fiber into private homes, shared properties or small business premises
• Replacement of damaged fiber after digging or renovation
• Re-routing fiber to a new cabinet, room or termination point
• Installation in microducts where controlled cable movement is important
• Project work where documentation and traceability are required

How We Carry Out Fiber Blowing and Jetting

We prepare the route, check access and adapt the method to the duct, microduct, distance, bends and site conditions.

The work can include:

• Review of route, duct and access before start
• Setup of compressor, blowing machine and cable handling equipment
• Controlled fiber blowing or jetting
• In-process checks during installation
• Preparation for splicing, termination or further work
• Labeling, documentation and handover basis when required

Equipment and Method
Fibertel uses practical field equipment for fiber blowing, jetting and installation in ducts and microducts. The method is selected based on route length, duct condition, available space and project requirements.
Our goal is stable progress, controlled installation, clean execution and documentation that makes the delivery easier to inspect, take over and troubleshoot later.
Related Pages
▶ Fiber Contractor Vestfold
▶ Fiber Contractor Sandefjord
▶ Fiber Splicing and Termination
▶ Fiber to the Home
▶ Photo Gallery
▶ Contact

Examples From Fiber Blowing and Jetting in the Field
The videos below show practical examples of fiber blowing, equipment setup, field monitoring and fiber installation. They are included to show how the work is performed in real project environments.

Examples of fiber blowing and jetting in the field

Service trailer for fiber blowing- compressor and blowing machine setup

Real- time monitoring during fiber blowing- camera rig at the receiving point

We support FTTH and FTTB delivery with fiber blowing/jetting, splicing and termination, work in nodes and technical rooms, and testing, documentation and handover.

Service trailer for fiber blowing- compressor and blowing machine setup

Fibertel delivers fiber and telecom infrastructure as a subcontractor across Vestfold, Telemark and Buskerud.
Scope includes FTTH and FTTB delivery, fiber blowing/jetting, splicing and termination, work in nodes and technical rooms, and testing, documentation and handover support.